While reviewing the datasheets for CM4/CM5 and layouts for CM4IO/CM5IO, I noticed that the CM4 uses a Hirose connector, whereas the CM5 uses an Amphenol connector.
Are these connectors interchangeable? I assume not, since the CM5 datasheet specifies only the Amphenol part, and the CM4 datasheet only lists the Hirose part.
Additionally, how do you generate the pick-and-place data for CM4IO/CM5IO? The entire module appears as a single footprint, but the pick-and-place process requires placing two separate connectors.
Are these connectors interchangeable? I assume not, since the CM5 datasheet specifies only the Amphenol part, and the CM4 datasheet only lists the Hirose part.
Additionally, how do you generate the pick-and-place data for CM4IO/CM5IO? The entire module appears as a single footprint, but the pick-and-place process requires placing two separate connectors.
Statistics: Posted by batwing — Mon Feb 10, 2025 11:51 am