Thank you for your quick response, that was really helpful.
I believe I have identified the issue with my previous setup.
The cameras I initially used from the Quadrascopic OV9281 kit are a special version that cannot be used individually on a Raspberry Pi or Jetson, as highlighted below:
I have since tried the full setup using the Camarray HAT UC-512 Rev.D1 with 4× Arducam UC-788 Rev.B, but I have not been successful so far. Additionally, I am uncertain which guide and OS version would be best suited for a Raspberry Pi 5.
Has anyone managed to get this configuration up and running?
I would greatly appreciate any guidance or recommendations you could provide.
Thank you again for your support.
Tinka
I believe I have identified the issue with my previous setup.
The cameras I initially used from the Quadrascopic OV9281 kit are a special version that cannot be used individually on a Raspberry Pi or Jetson, as highlighted below:
https://www.arducam.com/product/arducam ... amera-hat/The OV9281 cameras in this kit are a special version and cannot be used on Raspberry Pi or Jetson individually.
I have since tried the full setup using the Camarray HAT UC-512 Rev.D1 with 4× Arducam UC-788 Rev.B, but I have not been successful so far. Additionally, I am uncertain which guide and OS version would be best suited for a Raspberry Pi 5.
Has anyone managed to get this configuration up and running?
I would greatly appreciate any guidance or recommendations you could provide.
Thank you again for your support.
Tinka
Statistics: Posted by tinka_io — Sun Mar 16, 2025 9:29 pm