I just purchased a Raspberry Pi 5 board to replace a Pi 4 board. Also has a 7" touch display. The ribbon cable from the display to the Pi 4 board was the same width on both ends and worked fine, but the Pi 4 end is too wide for the Pi 5 board. I ordered what I thought was a suitable replacement cable. What came was a fine fit for the display and had a decent looking necked down end for the Pi 5 board, but it is just 1 or 2 mm too wide for the Pi 5 receptacle. Is there a specific part number for the correct cable to adapt the display to the Pi 5 board. The cable on the Pi 4 board has the number AWM 20706 105C 60V VW-1, has 15 pins and came with the display.
What is needed is the same out of the Display (~16mm) and necked down to the Pi 5 receptacle (~8.5mm) at 6" length
Any help would be appreciated
thx
Statistics: Posted by angels80 — Tue Apr 15, 2025 12:18 am