Hi, it is showing up as unknown device from the USB hub.
These steps were taken onto the mini SD card per chat GPT:
dtoverlay=dwc2 was added to config.txt
modules-load=dwc2,g_ether to cmdline.txt
ssh (no extension) existed in the boot partition.
It's possible the cable is a charge only one. I will have to switch it out. It is on an older splitter that goes from USB to a few older types of connectors. So a USB hub is connected to the PC, and then a splitter off to the pi. Probably not good.
Not sure about the socket. I will find some better cabling.
These steps were taken onto the mini SD card per chat GPT:
dtoverlay=dwc2 was added to config.txt
modules-load=dwc2,g_ether to cmdline.txt
ssh (no extension) existed in the boot partition.
It's possible the cable is a charge only one. I will have to switch it out. It is on an older splitter that goes from USB to a few older types of connectors. So a USB hub is connected to the PC, and then a splitter off to the pi. Probably not good.
Not sure about the socket. I will find some better cabling.
Statistics: Posted by shs125 — Wed Apr 16, 2025 3:12 am