Hello,
I have a pico RP2350 but i'm unable to flash it anymore. It used to work, but all of the sudden it didn't. After i put the cable out, and back in it didn''t start again. It was running circuitpy. I tried several times to flash it manually, and also tried to flash it in Thonny. Every time when i flash it in Thonny i'll get the error: could not find port. And when i'll try to flash it manually: the uf2 file is copieing to the pico, then it disappears in windows to come back in a second (again in boot mode thus no files on it)
I already tried:
a flash_nuke < -- no result
a blink.uf2 < -- no result
Hard reset (pin 30 to ground) < -- no result
Is it somehow possible to restore?
Thnx
I have a pico RP2350 but i'm unable to flash it anymore. It used to work, but all of the sudden it didn't. After i put the cable out, and back in it didn''t start again. It was running circuitpy. I tried several times to flash it manually, and also tried to flash it in Thonny. Every time when i flash it in Thonny i'll get the error: could not find port. And when i'll try to flash it manually: the uf2 file is copieing to the pico, then it disappears in windows to come back in a second (again in boot mode thus no files on it)
I already tried:
a flash_nuke < -- no result
a blink.uf2 < -- no result
Hard reset (pin 30 to ground) < -- no result
Is it somehow possible to restore?
Thnx
Statistics: Posted by Jacco Walraven — Sun Jun 08, 2025 1:35 pm